Post by wilee68 on Aug 13, 2013 17:38:13 GMT -5
Sorry that it took me so long to post this, and I hope that everybody that asked finds this, but here are some pics of the stock I put the Hammer7 into to make my sniper-esque rifle.
Basically, I just hogged out the whole insides, then determined where my two mounting holes would be. Once I established that, I used bondo and JB weld to fill back in the hogged out areas into the shape that would accept the hammer. You'll notice the bulge in front of the magazine - that is jb weld and is needed for the forward mounting hole of the Hammer. The ASA is an old "duckbill" ASA that I cut the front hole off, recessed a place in the grip, mounted then grinded the shape to flow with the grip area the best I could. Once I established that, I started grinding out a place for the HPA bottle, once I had enough clearance, I filled that back in with bondo until I had the space/shape that I wanted.
I hope this helps.
D
Basically, I just hogged out the whole insides, then determined where my two mounting holes would be. Once I established that, I used bondo and JB weld to fill back in the hogged out areas into the shape that would accept the hammer. You'll notice the bulge in front of the magazine - that is jb weld and is needed for the forward mounting hole of the Hammer. The ASA is an old "duckbill" ASA that I cut the front hole off, recessed a place in the grip, mounted then grinded the shape to flow with the grip area the best I could. Once I established that, I started grinding out a place for the HPA bottle, once I had enough clearance, I filled that back in with bondo until I had the space/shape that I wanted.
I hope this helps.
D
Attachments:
