|
|
Post by PzPicklez on Aug 13, 2011 12:57:27 GMT -5
My MR1 keeps blowing air threw the gun when i screw the co2 in. Can someone help me fix this problem?
|
|
|
|
Post by Soldier of Fortune on Aug 13, 2011 16:29:29 GMT -5
I would suggest removing the bolt and the striker. check the o-rings on them. If they are all intact remove the regulator from the front of the gun and check the orings there. oil or grease everything if all orings are intact as the air may blow past orings that are dry and not sealing. IMPORTANT: When reinserting the striker remove the grip frame first or the sear will cut the oring.
|
|
|
|
Post by Lt.Col.Vortex on Aug 13, 2011 22:56:43 GMT -5
Sweet( not sweet that your gun is acting up) but sweet that my brother had the same problem with his and he fixed it.
OK, a few things first, when did this happen? did your marker set long then start actin up? did you replace the orings and it still do this?
Heres what my brother had and did to fix. His was leaking out the barrel, ad he replaced all the orings. He tried spring tensions, but it still leaked. What we think it was, is the valve body and the valve pin. The pin had a teflon seal on it that seats to the valve body. Check your valve body and seal for damage.
What he did in the end was get an upgraded valve body with valve pin and springs. It fixed the problem and it was an upgrade at the same time.
Oh and we shoot Co2 also, but the upgrade valve allows you to shoot HPA too( actually it just gives better performance if you shoot HAP)
|
|
|
|
Post by Lt.Col.Vortex on Aug 13, 2011 23:13:29 GMT -5
|
|
|
|
Post by PzPicklez on Aug 16, 2011 17:47:54 GMT -5
I'm having the same problems as ur bro, vortex. I guess i'll buy those replacement parts. Thx guys.
|
|
